BMW 5 Series E39

since 1996-2001 release

Repair and operation of the car



BMW E39
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Cooling systems, heating
- Power supply system and release
   + Power supply system
   - System of injection of the petrol engine
      Memory of malfunctions
      Security measures and rules of respect for purity during the work with system of injection
      Work of system of injection
      Check of systems of ignition and injection
      Adjustment of the drive of gas
      Removal and installation of a branch pipe of a butterfly valve
      Removal, check and installation of the valve of adjustment of idling
      Check, removal and installation of the sensor of temperature
      Check of injectors
      Removal and installation of injectors
   + Power supply system of the diesel engine
   + System of production of the fulfilled gases
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment
+ System of onboard diagnostics




Check of injectors

Injectors give fuel pulsewise. At the same time the injection has the conical form. After the end of injection the gate of an injector is densely closed. Leakage of injectors leads to difficulties at start of the heated-up engine. Faulty injectors lead to operation of the engine after its switching off for some time and lead to interruptions.

 CHECK

1. Uncover injectors.
2. Start the engine on single turns.
3. On the working engine a stethoscope listen to each injector. Gates of injectors have to click when opening and closing.
4. If there is no stethoscope, it is possible to put the screw-driver or a finger.
5. If unusual noise or absence it is found, it is necessary to check tension, resistance and tightness of injectors.

Check of tension and resistance of injectors

 PERFORMANCE ORDER

1. Check tension. For this purpose to a rasstykuyta shtekerny connection of injectors also attach a diode control lamp between contacts of wires of food. Include a starter. The light-emitting diode has to blink.
2. If the diode does not blink, wire breakage or malfunction of the control unit can be the cause.
3. Switch off ignition.
4. Attach an ohmmeter between both contacts on each injector and measure resistance. If resistance differs from set, replace an injector. Resistance has to be 15 — 17.5 Ohms.
5. If necessary replace a faulty injector.

Tightness check

 PERFORMANCE ORDER

1. Remove injectors. Do not disconnect fuel-supply lines from the distributive highway.
2. Attach a plug to injectors.
3. Lower injectors in capacity.
4. Ask the assistant several seconds to press a starter. Compare the nature of injection of injectors among themselves. All injectors have to have a cone-shaped injection and identical.
5. Switch off ignition.
6. Disconnect a plug level of injectors.
7. Include on 5 about ignition, without including a starter. Check tightness: within one minute one drop, has to be formed no more.
8. Establish injectors.


BMW tightness is checked for HUNDRED by compressed air. Untight injectors are processed in the ultrasonic device of cleaning by means of a cleaner.









64a8d164 64a8d164 64a8d164 64a8d164