| 1. Periodically check liquid level in system of hydrostrengthening of a wheel in order to avoid emergence of problems with management of the car, such as damage of the steering pump. Act as follows.
|
| Do not hold a steering wheel turned against the stop in this or that party more than five seconds. It can put the steering pump out of action. |
|
2. The tank of system of hydrostrengthening of a wheel is located in the left part of a motive compartment and has the unscrewing cover with the measuring probe which is built in in it. |
|
3. Park the car on the flat platform and cock the parking brake.
4. Level of oil can be checked at cold or heated-up oil. Heated-up oil has temperature about + 80 °C, cold oil has ambient temperature.
5. Turn off an oil tank stopper on the cooled engine. Wipe the index of level on a stopper with a pure rag. |
6. Put a cover on a mouth, without screwing up it, and remove again. Level of oil has to be between tags on the index. If necessary add oil. The added oil has to be authorized BMW. Add surely new oil since even insignificant pollution can cause failures of the hydraulic booster. |
|
7. Start the engine and if necessary add oil that it was between marks in the index.
8. At the working engine turn several times a steering wheel from an emphasis against the stop. Thus from system air is removed.
9. Stop the engine.
|
| The modulation of liquid is allowed no more than 5 mm above the MOVE. Remove surplus with the pure syringe. Close a cover. |
Check sealing rings on a stopper. If necessary replace.
10. Close the tank a stopper.
11. If the frequent dolivaniye of liquid is required, check hoses and nipple connections of system of hydrostrengthening of a wheel for existence of signs of wear and leaks.
12. Check a condition of a driving belt (address the Section Check of a Condition of Driving Belts). |
