BMW 5 Series E39
since 1996-2001 release
Repair and operation of the car
- Maintenance instruction
Governing bodies, devices and control lamps
Locking devices and anticreeping alarm system
Equipment of salon
Gas station of fuel, start and stop of the engine
Manual Box of Gear Shifting (MBGS)
Automatic Transmission (AT) *
The alarm system of emergency rapprochement at the parking (PDC) *
System of automatic stabilization of stability with the regulator of traction effort (ASC+T)
Electronic adjustment of rigidity of depreciation (EDC) * and adjustment of a road gleam
System of heating and ventilation
Automatic conditioner *
Autonomous systems of heating and ventilation
System of self-diagnostics *
Anti-blocking system of brakes (ABS)
The movement with the trailer
Luggage carrier on a roof
Automobile phone *
Readjustment of headlights
Automobile radio receiver
The Hi-Fi audio system with DSP *
Sign of an emergency stop *
First-aid kit *
+ Current leaving and service
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Onboard electric equipment
+ Schemes of electric equipment
+ System of onboard diagnostics
Equipment of salon
On a door of the forward passenger and in a back part of a body (at a complete set of back doors power windows *) under glasses installed separate switches.
Going out of the car, always take with yourself the ignition key that, for example, children could not put window regulators in action and put itself a trauma.
After switching off of ignition the possibility of use of window regulators remains if:
Travmozashchitny function of power windows
If at the time of raising of glass to concern rack contact at the upper edge of an aperture, then glass will stop and will a little be lowered a little.
This function can be turned off (for example, in attempt of the stranger to get into the car outside) if to hold the window regulator switch in the provision of startstopny control mode.
Switch safety lock
The hatch with a lifting and movable cover *
Uncontrollable, without appropriate care closing of a lifting and movable cover of the hatch can lead to injuries. Going out of the car, always take out a key from the ignition lock that, for example, children could not involve a cover of the hatch and put itself a trauma.
In salon there will be no depression and drafts if at the opened or lifted cover of the hatch pressure-blowing openings are completely open and - in case of need - air supply will be increased.
After switching off of ignition the possibility of use of the hatch remains if:
About automatic opening and closing of a cover of the hatch by turn of a key in the lock of a door or by means of remote radio control address Section materials Locking devices and the anticreeping alarm system.
Automatic * opening and closing
The cover of the hatch opens and closed automatically if you shift the switch in the corresponding direction for a point of the increased resistance and then release it.
At an open cover the switch contact in the Lift direction allows to shift a cover in the final provision of rise.
At the raised cover the switch contact in the Open direction allows to shift a cover in final open situation.
The repeated contact of the switch allows to stop the movement.
It is impossible to raise the closed cover in this mode.
If in the course of closing the hatch cover approximately in the middle of the course encounters an obstacle, then it will stop and will slightly be removed back.
This function can be turned off (for example, at the heavy course of a cover on guides in frosty weather, or in attempt of the stranger to get into the car outside) if to translate the switch for a point of the increased resistance and to hold it in this situation.
De-energization or malfunction
Management of a cover and its work are carried out in the same way as is described earlier. To open the raised cover, hold the switch in situation "Open" until the cover reaches required position.
If the cover of the hatch rises, then the cover in a ceiling upholstery moves a little back, and when opening it opens together with a hatch cover. It remains in open situation and if necessary can be closed at any time.
Sun-protection curtain *
Sun-protection curtains of back side glasses *
Each of curtains is extended for a loop and fixed in the fastening.
Seats as the most important element of the chain connecting the person, running gear and the road were developed with special care. At the same time the most modern methods as, for example, SAPR (system of automatic design), methods of final elements, and also control systems with electronic control were used.
Extent of depreciation of shock influences from the road was carefully brought into accord with characteristics of a running gear. The stable bearing design of seats provides together with seat belts, natyazhitel of belts and, certainly, inflatable safety cushions the highest level of safety. Thanks to multilayered structure of a filler of seats, high percentage of natural fibers and difficult internal system of ventilation of a seat of people during the movement - and even on long trips - feels it is weakened and is not tired. Lumbar and humeral support provide optimum position of a backbone.
Adjustment of seats
For the sake of your personal security we appeal to you to follow the following rules of adjustment of seats.
Do not regulate the driver's seat on the run. Its unexpected shift can cause loss of control over the car and lead to accident. The seat belt has to as it is possible to adjoin to a body more densely. Otherwise at head-on collisions the zone belt can come off up hips and injure the lower part of a stomach. Besides at leaky adjacent belt its holding effect is implemented with delay.
Inadmissibly, that during the movement of the car the back of a front seat deviated far back (it concerns first of all a passenger seat) as at the same time in case of accident there is a danger of "slipping" of the person under a seat belt which in that case will not be able to execute the protective function.
Front seats cannot be shifted back if the car moves under a bias (for example, on a ramp of multystoried garages or on mountain roads) as at the same time unhitching of system of automatic adjustment of a belt on height is possible.
Seats with manual adjustment
For unloading of vertebral disks you sit down with the maximum shift back, leaning all back on a seatback. The pose at which the head settles down on one straight line with a backbone is considered ideal.
To reduce tension of muscles at distant trips, it is possible to increase a back inclination several. At the same time, however, possibility of driving when the hands lying on the highest point of a wheel are slightly bent in elbows has to remain.
Lumbar support *
See the description of a company seat of the increased comfortableness below.
Seats of sports type *
Seat with electroadjustment *
The tilt angle of a head restraint is regulated manually.
For the sake of your personal security surely observe the instructions on adjustment given above.
Company seat of comfortable type *
1. Lumbar support
Pressing the switch in front or behind reaches respectively increase or reduction of camber of a contour of a back.
By pressing the top or lower part of the switch the convex zone of a contour is displaced up or down.
The contour of a back can change so that its acting part fitted into a hollow of lumbar department of a backbone, creating a support for it.
Thus, support of the top department of a basin and a backbone promoting the correct and free landing is provided.
2. Humeral support
Installation of seats will be optimum at observance of the recommendations given below.
For the driver and forward passenger:
For the forward passenger at the back rejected back:
Changing the longitudinal provision of a seat, achieve that the seat belt, as before, densely adjoined to a body, otherwise it will not be able to execute the protective function.
Heating of seats *
Adjustment of provision of a steering wheel
Adjustment of a steering wheel is possible in four directions, relevant provisions of the lever of the switch.
About operation of the device which is memorable installation of a steering wheel, and also seat and mirrors address materials below in this Section.
Heating of a steering wheel *
External rear-view mirrors
As a result of pressing a key of a mirror nestle on a body or get divorced in the parties that is convenient at journey through a sink, at movement along narrow streets, and also for return of mirrors to a starting position if they were earlier incidentally displaced forward.
It is possible to press mirrors to a body only at the motionless car or at a speed no more than 10 km/h.
The provision of mirrors can be regulated and manually, turning them for a fringing of glasses.
About operation of the device which is memorable installation of mirrors, and also a steering wheel and seat address materials below in this Section.
External, aspherical a curved part of a reflective surface provides at some distortion of the image the bigger sector of the review in comparison with an internal, convex part. As a result the corner of a rearview increases and the so-called "dead" zone is reduced.
The mirror, distant from the driver, has more convex reflective surface in comparison with a mirror on the driver's door. The objects seen in it seem more remote, than actually. Therefore it is only conditionally suitable for distance assessment to the vehicles moving behind. Told treats also a curved part of a mirror external aspherical.
Heating of both mirrors is carried out automatically depending on air temperature at turn of the ignition key in situation 2.
Rear-view mirror in salon
Cosmetic mirrors with illumination *
To use a mirror, cast away a sun-protection peak down and if the mirror is closed, shift its cover aside.
Illumination of mirrors joins already at installation of the ignition key in situation 1.
It is possible not only to throw back peaks down, but also to take aside to side glasses.
No-glare rear-view mirror * in salon
For normal work of a mirror it is important to cover with nothing and to keep clean its photo cells. The light sensor directed forward measures intensity of light in front of the car in the case of a mirror. The second light sensor is in the mirror. The electronic system of adjustment compares values of intensity of light in front and behind. The difference of values is the defining size for change of voltage on a liquid crystal layer of a mirror. This layer reacts to change of tension and provides smooth blackout of a mirror. Thus, need most disappears to regulate mirror blackout degree that allows the driver to concentrate the attention on the road completely.
Set of no-glare mirrors *
Both external rear-view mirrors are executed also with a possibility of automatic smooth reduction of reflective effect. Besides, using a key 3 (illustration), they can be put and again to open in the parties.
The device which is memorable provisions of a seat, mirrors and a steering wheel *
1. Having inserted a key into the ignition lock, turn it in situation 1 or 2.
The ignition key is in situation 1:
The door of the driver is closed, and the key in the lock of ignition is turned in situation 0 or 2 or in general will take out from it:
Automatic correction of provision of a mirror at the movement by a backing
In order to avoid injuries at accidents it is recommended not to leave a ware box without need open.
Accumulator portable lamp *
The lamp is at the left in a ware box.
Thanks to existence of the device protecting its accumulator from a recharge it can be stored constantly included in the socket.
It is possible to insert a lamp a fork into the socket only in the switched-off state, otherwise there is a danger of an overload and damage of a lamp.
Compartments for storage of small things
The open compartment is to the left of a steering column.
If the car is completed with a compartment with a folding cover *, then to open it, it is necessary to pull for the handle down and to close - it is necessary to slam a cover the movement up.
Compartment on the average console between two front seats. To open a compartment, it is necessary to undertake dredging in front and to pull a cover up. In this compartment a telephone is installed if you wish to equip with it the car.
You will find pockets or niches for small things also on any of doors and from the back of backs of lobbies сидений*.
The holder for cans with drinks *
Ashtray in front *
This nest can use as the plug socket for connection of a portable lamp, vacuum cleaner and other consumers of current with a power about up to 200 W and with working voltage of 12B. On the car in a complete set for non-smoking the lighter is closed by a removable cap. In order to avoid damage of a nest of the lighter do not try to insert into it an improper fork.
Ashtrays behind *
The device for transportation of lengthy objects *
Cover for transportation of skis *
In a cover it is possible to transport, without being afraid for their safety and purity of salon, to four couples of skis.
Taking into account length of a cover and additional space in a luggage carrier it is possible to load skis up to 2.10 m long in the car. When loading skis 2.10 m long the capacity of a cover is reduced so it can include no more than two couples of skis of the specified maximum length.
Removal of a back dividing armrest
Installation of an armrest
Insert an armrest from above and press it down so that it was heard as it will be latched in holders.
You watch that side pins did not damage a seat upholstery.
Cover for transportation of skis in combination with the device for transportation of lengthy objects