Initialization of remote control of the uniform lock
Remote control of the uniform lock has to be initialized if replacement of batteries in a key was made, and this replacement lasted more than 1 min. or if at the same time the key was pressed. To replace batteries, address appropriate section of the Head the Current leaving and service.
|
| 1. Get into the car and close the driver's door.
2. Turn for a short time the ignition key in the lock of a steering wheel in situation 1 (not longer 5 c) and again turn it back. |
3. Take out the ignition key, press a key (2) and you hold it. Press a key (1) three times (not longer than 10 pages). At the same time hold a key (2). |
|
4. Release a key (2).
5. For check of the executed initialization set in motion electric motors of the uniform lock from the monitor twice. |
|
|
